Python [ BabySploit Beginner Pentesting Toolkit/Framework ] - Intech Network

Ethical-Hacking & penetration testing & network security assessments

11/20/2018

Python [ BabySploit Beginner Pentesting Toolkit/Framework ]



BabySploit is a penetration testing toolkit aimed at making it easy to learn how to use bigger,
more complicated frameworks like Metasploit. With a very easy to use UI and toolkit, anybody
from any experience level will find use out of BabySploit. Below are some screenshots of the framework.

# Installation Instructions:
BabySploit is best run out of the home directory so to clone it there run:
git clone git://github.com/M4cs/BabySploit ~/BabySploit
cd ~/BabySploit
After cloning the installation you must install some pre-requisites. If you are on Kali you should already have all of these installed but it doesn't hurt to do so anyways just in case. Do so by running the following:
If you are not on Kali you need to add the Kali repository to your APT Sources list and then run install.
~- From Within The BabySploit Directory -!
sudo apt-get update
sudo apt-get upgrade
sudo python3 install.py
virtualenv babysploit
source babysploit/bin/activate
pip3 install -r requirements.txt
python3 start.py

!- To Leave The Virtual Environment -!

deactivate


Getting Started:

Setting Configuration Values:

BabySploit uses ConfigParser in order to write and read configuration. Your config file is automatically generated and located at ./babysploit/config/config.cfg. You can manually change configuration settings by opening up the file and editing with a text editor or you can use the set command to set a new value for a key. Use the set command like so:
set rhost
>> Enter Value For rhost: 10
>> Config Key Saved!
If before running this command the rhost key had a value of 80, the rhost key after running this command has a value of 10. You can also add configuration variables to the config by using the set command with a new key after it like so:
set newkey
>> Enter Value For newkey: hello
>> Config Key Saved!
Before running this there was no key named "newkey". After running this you will have a key named "newkey" in your config until you use the reset command which resets the saved configuration.

Running A Tool

In order to run a tool all you have to do is enter the name of the tool into BabySploit. You can use the tools command to display a menu with all the currently availble tools.

Aucun commentaire:

Enregistrer un commentaire